Monthly Archives: May 2012

All in One Skimmer

Posted on May 7, 2012 by robertwilkie

Amazing how these things are moving along, custom molding with a 3-D printer.  Off the shelf hardware…. https://krebsonsecurity.com/2012/04/skimtacular-all-in-one-atm-skimmer/?utm_source=feedburner&utm_medium=feed&utm_campaign=Feed%3A+KrebsOnSecurity+%28Krebs+on+Security%29

Posted in CNC/3D-printing, Security | Comments Off on All in One Skimmer

Shmoocon 2012: GHz or Bust! – Different use for TI’s EZ430 Chronos watch

Posted on May 7, 2012 by robertwilkie

Interesting talk about using TI’s EZ430 Chronos watch to snoop on wifi.  Watch it below. http://dangerousprototypes.com/2012/04/24/shmoocon-2012-ghz-or-bust/  

Posted in Security, TI | Comments Off on Shmoocon 2012: GHz or Bust! – Different use for TI’s EZ430 Chronos watch

Interesting RFID Shield for Arduino

Posted on May 6, 2012 by robertwilkie

This is an interesting shield that supports RFID…it has allot of potential for using in PEN testing in security.  I haven’t read up too much on it, but its worth looking at more details in the future. http://www.open-electronics.org/arduino-rfid-shield/

Posted in Arduino, Security, sensors, Tinkering | Comments Off on Interesting RFID Shield for Arduino

Cheap waterproof lights

Posted on May 6, 2012 by robertwilkie

I know I will be building one of these (at least) for the pool.  Its a neat idea that takes a few simple PVC pipe materials, an LED, and a battery to make a very solid light.  Stay tuned, you … Continue reading →

Posted in Tinkering | Comments Off on Cheap waterproof lights

Sparkfun has published several simple classes

Posted on May 6, 2012 by robertwilkie

Sparkfun has put up several learning and intro documents up.  Could be a good reference for teaching younger experimenters.  Read up on it below. http://learn.sparkfun.com/curriculum

Posted in Teaching and Learning, Tinkering | Comments Off on Sparkfun has published several simple classes

Cheap rail for CNC

Posted on May 6, 2012 by robertwilkie

Stumbled on this interesting post of how to built your own cheap rail for a CNC.  Most bought rails can run quite a bit of cash, so this is a nice alternative if you have the tools and patience to … Continue reading →

Posted in CNC/3D-printing | Comments Off on Cheap rail for CNC

A thumbdrive smartcard

Posted on May 1, 2012 by robertwilkie

Leave it to the Germans to come up with something clever, a thumb drive that mimics a smart card for authentication, etc etc.  The have an open source (or you can buy) solution.  Read more here http://www.crypto-stick.org/

Posted in Security | Comments Off on A thumbdrive smartcard