Nice starting point for CNC software

Posted on December 23, 2013 by robertwilkie

Nice write-up from hack-a-day on a good starting point for software for CNC.  It goes over free, cheap, and not so cheap solutions that a tinker could afford.

http://hackaday.com/2013/12/23/software-advice-for-anyone-thinking-about-a-cnc-router/?utm_source=feedburner&utm_medium=feed&utm_campaign=Feed%3A+hackaday%2FLgoM+%28Hack+a+Day%29

This entry was posted in CNC/3D-printing. Bookmark the permalink.